Q: In
converting my 356 from 6 volt to 12, I'm considering using the
larger diameter, higher output generator used in the late 912s
and VWs. Does anybody have any thought about doing this other
than cosmetics?
A: If you want to convert to the Large Diameter
912 Generator, you will
need:
- The Large Diameter Generator
- The Generator Strap for the Large Diameter Generator
- The special Fan that fits only the Large Diameter
912 Generator, and its special hole covering piece that goes on the opposite side of the Fan from where every other piece goes!
- Both of the two Special Generator Shroud Pieces that fit only the Large Diameter 912 Generator
- The Special hub for the Fan that fits only the Large Diameter 912 Generator
- The Special Nut for the Fan (The same as the Generator Pulley Nut, but different from all previous Fan Nuts that weren't the same as Generator Pulley Nuts.)
- A Larger reinforcing plate that goes over the 2 studs to help hold the Generator shroud.
And, since the
Generator Stand for the Large Diameter Generator Stand has
the oval-shaped hole, you can only fit the C/912 Breather
Can to it, not
the Flip Top Box 356A/B Breather!
Frankly, wouldn't it be easier
to get a small Diameter early 912 12V
Generator? Then all your existing stuff will work OK.
--Harry Pellow
Technical advice given on
these pages is provided free and without warranty. The user of
information presented on these pages assumes all responsibility
and liability in its use. We're not lawyers, we're car folk,
just sharing our experience. Be careful, use your head, have
fun.
